SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 79 (ENGINE MECHANICAL (SERVICE INFORMATION))ENGINE IDENTIFICATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Engine Identification

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Engine Identification
WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For repair procedures not covered in this article, see ENGINE OVERHAUL PROCEDURES article in GENERAL INFORMATION and 3.0L (AJ WITHOUT VARIABLE VALVE TIMING ) V6 OVERHAUL - MAZDA6 & MPV article.

Engine may be identified by eighth character of Vehicle Identification Number (VIN), located on top of instrument panel, near lower left corner of windshield. VIN is also stamped on Vehicle Certification (VC) label, mounted on left door pillar.

An engine identification label is located on engine. This label contains information for engine identification. An emission calibration number label is located on left door or pillar. Information from labels is required when ordering replacement parts.

ENGINE IDENTIFICATION CODE

Engine VIN Code
3.0L 8 NA
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.