SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 690 (ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM L3) (5 OF 5))DTC P2676NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P2676: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC P2676 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2676 Variable air duct (VAP) solenoid valve circuit low input
DETECTION CONDITION  California emission regulation applicable ATX model 
  • The PCM monitors the VAD solenoid valve control signal voltage and current. If the following conditions are met, the PCM determines that there is the VAD solenoid valve circuit problem.
    • The PCM turns the VAD solenoid valve off, but the voltage of the VAD solenoid valve control signal remains low.

Diagnostic support note 
  • This is a continuous monitor (Other).
  • MIL does not illuminate.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is not available.
  • DTC Is stored in the PCM memory.
Except for California emission regulation applicable ATX model 
  • The PCM monitors VAD solenoid valve control signal. If the PCM turns VAD solenoid valve off but voltage still remains low, the PCM determines that VAD solenoid valve circuit has malfunction.

Diagnostic support note 
  • This is a continuous monitor (Other).
  • MIL does not illuminate.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is not available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • VAD solenoid valve malfunction
  • Open circuit in wiring between main relay and VAD solenoid valve terminal A
  • Open circuit in wiring between VAD solenoid valve, terminal B and PCM terminal 1K
  • Short to ground in wiring between VAD solenoid valve terminal B and PCM terminal 1K
  • Connector or terminal malfunction
  • PCM malfunction
G04324066Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.