SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 690 (ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM L3) (5 OF 5))DTC P2228NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P2228: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC P2228 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2228 BARO sensor circuit low input
DETECTION CONDITION 
  • PCM monitors input voltage from BARO sensor. If input voltage is below 2.1 V (1) , 1.95 (2)  , PCM determines that BARO sensor circuit has malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if PCM detects the above malfunction condition during first drive cycle.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • BARO sensor malfunction
  • PCM malfunction
(1) California emission regulation applicable ATX model
(2) Except for California emission regulation applicable ATX model
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.