Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 689 (ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM L3) (4 OF 5))DTC P0505NOTES

2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0505: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes

WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0505 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0505	Idle control system malfunction
DETECTION CONDITION	PCM cannot control idle speed toward target idle speed while KOER self test.
POSSIBLE CAUSE	Electronic throttle control system malfunction Clogged air cleaner element Clogged air intake passage A/C relay control circuit malfunction Generator control circuit malfunction Low engine compression (Over capacity of blow-by gas) PCM malfunction

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.