SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 687 (ON-BOARD DIAGNOSTIC (ENGINE CONTROL SYSTEM L3) (2 OF 5))DTC P0037EXCEPT CALIFORNIA EMISSION REGULATION APPLICABLE ATX MODELNOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Except California Emission Regulation Applicable ATX Model: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0037 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0037 Rear HO2S heater circuit low input
DETECTION CONDITION 
  • The PCM monitors the rear HO2S heater output voltage. If the PCM turns the rear HO2S heater off or on but the rear HO2S heater circuit remains low voltage, the PCM determines that the rear HO2S heater circuit has malfunction.

Diagnostic support note 
  • This is a continuous monitor (HO2S heater).
  • MIL illuminates if PCM detects above malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for the same malfunction has been stored in PCM.
  • PENDING CODE is available if PCM detects the above malfunction-condition during first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Rear HO2S malfunction
  • Open circuit in wiring harness between the ignition switch and rear HO2S terminal C
  • Open circuit in wiring harness between rear HO2S terminal D and PCM terminal 2BE
  • Short to ground in wiring harness between rear HO2S terminal D and PCM terminal 2BE
  • Poor connection at the rear HO2S or the PCM connector
  • PCM malfunction
G04324001Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.