SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 672 (GLASS/WINDOWS/MIRRORS)POWER WINDOW MOTOR REMOVAL/INSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Power Window Motor Removal/Installation

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Power Window Motor Removal/Installation
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
  3. Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
  4. Remove the bolts.
  5. Remove the power window motor from the power window regulator drum.
    6. Fig 1: Removing Power Window Motor From Power Window Regulator Drum With Torque Specifications
    G04564263Courtesy of MAZDA MOTORS CORP.
  6. Disconnect the power window motor connector.
  7. Install in the reverse order of removal.
    NOTE:
    • When installing the power window motor to the power window regulator drum, the drum housing tab may come off the door unit. lf this happens, remove the door speaker, insert your hand in the speaker installation hole, connect the drum housing tabs, and while supporting the drum housing, install the power window motor to the drum. 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.