SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 672 (GLASS/WINDOWS/MIRRORS)BASE INSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Base Installation

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Base Installation
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cut away all of the original sealant using a razor.
  2. Clean and degrease the ceramic coating on the glass and the base.
  3. Apply primer to the bonding area of the glass and the base.
    CAUTION:
    • Keep the area free of dirt and grease, and do not touch the surface. Otherwise, the primer may not properly bond to the surface of the glass. 
  4. Apply a 3.0 mm {0.12 in}  layer of sealant to the base.
    NOTE:
    • Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for  approx. 30 min. 
      Fig 1: Applying Sealant To Base
      G04564293Courtesy of MAZDA MOTORS CORP.
  5. Center the base in the ceramic coating and press it onto the glass.
  6. Use isopropyl alcohol to remove any excess repair sealant.
    Fig 2: Centering Base In Ceramic Coating
    G04564294Courtesy of MAZDA MOTORS CORP.
    HARDENING TIME OF SEALANT

    Temperature Surface hardening time Time required until vehicle can be put into service
    5 °C {41 °F} Approx. 1.5 h Approx. 12 h
    20 °C {68 °F} Approx. 1 h Approx. 4 h
    35 °C {95 °F} Approx. 10 min. Approx. 2 h
  7. Install the rearview mirror.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.