Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 67 (ENGINE CONTROLS - SELF-DIAGNOSTICS)SYSTEM TESTSFUEL INJECTOR INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Fuel Injector Inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Fuel Injector Inspection
WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
- Listen For Injector Operation - Warm up engine and run at idle (or cranking if engine will not start). Listen for "clicking" sound from fuel injectors (use stethoscope if necessary). If all fuel injectors are "clicking", go to step 3. If all fuel injectors are not "clicking", go to next step.
- Check Injector Resistance -
Disconnect suspect injector 2-pin harness connectors. Measure resistance of injectors. If resistance reading is 11-18 ohms at 68°F (20°C), check injector driver circuits from PCM.WARNING: Before performing following operation, release fuel pressure from fuel system to reduce possibility of injury or fire. See FUEL PRESSURE RELEASE under FUEL SYSTEM in BASIC DIAGNOSTIC PROCEDURES article.
- Check Injectors For Fuel Leakage - Remove fuel rail assembly from intake manifold. Connect fuel lines. Disconnect Inertia Fuel Shutoff (IFS) switch 3-pin harness connector. Install fused jumper wire between battery positive and IFS switch terminal No. 2 (Pink/Black wire) to run fuel pump. See appropriate WIRING DIAGRAM under ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS. Check for fuel leaks from injectors. If fuel leakage is less than one drop per 2 minutes, fuel injectors are okay. If fuel leakage is more than one drop per 2 minutes, replace leaking fuel injector. Replace O-rings and check for fuel rail damage. Repair or replace as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.