Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 657 (SECURITY SYSTEM AND LOCKS SYSTEM)FRONT DOOR KEY CYLINDER REMOVAL/INSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Front Door Key Cylinder Removal/Installation
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Front Door Key Cylinder Removal/Installation
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the following parts:
- Inner garnish (see INNER GARNISH REMOVAL/INSTALLATION .)
- Front door trim (see FRONT DOOR TRIM REMOVAL/INSTALLATION .)
- Front door glass (see FRONT DOOR GLASS REMOVAL/INSTALLATION .)
- Front door speaker (see FRONT DOOR SPEAKER REMOVAL/INSTALLATION .)
- Front door unit (see FRONT DOOR UNIT REMOVAL/INSTALLATION .)
- Front outer handle (See FRONT OUTER HANDLE REMOVAL/INSTALLATION .)
- Detach the front door key cylinder rod.
- Turn the front door key cylinder so that the tab is aligned with the notch.
- Remove the front door key cylinder by pulling it out from the front door.
- Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.