Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 656 (CONTROL SYSTEM (HVAC))CLIMATE CONTROL UNIT INSPECTIONOUTPUT SIGNAL INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Output Signal Inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Output Signal Inspection
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- After performing the on-board diagnostic test procedure, inspect according to the OUTPUT SIGNAL INSPECTION CHART :OUTPUT SIGNAL INSPECTION CHART
INSPECTION DISPLAY ACTION Inspect the climate control switch indicator lights. All indicator lights illuminate. Output signal from the audio unit is normal. Except above Replace the climate control unit. (See CLIMATE CONTROL UNIT REMOVAL/INSTALLATION .) - Disconnect the jumper wire or the similar device connected to the A/C amplifier connector (24-pin) to exit the on-board diagnostic test function.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.