SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 655 (ON-BOARD DIAGNOSTIC [DYNAMIC STABILITY CONTROL))DTC C1994 [DYNAMIC STABILITY CONTROL]NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC C1994 [Dynamic Stability Control]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
DTC C1994 DETECTION CONDITION AND POSSIBLE CAUSE

DTC C1994 DSC control
DETECTION CONDITION 
  • DSC control for the front wheels continues for 10 s or more. 
  • During DSC control, the pressure increase operation to any of the all four wheels does not occur for 1.3 s or more. 
POSSIBLE CAUSE 
  • This does not indicate a malfunction since constant control over extended period of time is inhibited to protect the DSC solenoid valve inside the DSC HU.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.