Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 655 (ON-BOARD DIAGNOSTIC [DYNAMIC STABILITY CONTROL))DTC C1222 [DYNAMIC STABILITY CONTROL]NOTES

2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC C1222 [Dynamic Stability Control]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes

WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

DTC C1222 will be detected when a malfunctioning ABS wheel-speed sensor cannot be specified.

DTC C1222 DETECTION CONDITION AND POSSIBLE CAUSE

DTC C1222		ABS wheel-speed sensor (slip monitor)
DETECTION CONDITION	Difference between any vehicle wheel speeds exceeds specification when driving at a constant speed. ABS control operates for 60 s or more.
POSSIBLE CAUSE	ABS wheel-speed sensor malfunction (low output, metal shavings on sensor) ABS sensor rotor malfunction (chipping of sensor rotor teeth) Poor installation of ABS wheel speed sensor and/or sensor rotor (If the sensor rotor is installed at an angle, it may cause output of abnormal wave pattern at high speeds). Excessive clearance between the ABS wheel-speed sensor and sensor rotor
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.