Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 655 (ON-BOARD DIAGNOSTIC [DYNAMIC STABILITY CONTROL))DTC C1093 [DYNAMIC STABILITY CONTROL]NOTES

2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC C1093 [Dynamic Stability Control]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes

WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

DTC C1093 DETECTION CONDITION AND POSSIBLE CAUSE

DTC C1093		DSC OFF switch
DETECTION CONDITION	Continuous ON signal from the DSC OFF switch for 5 s or more is detected.
POSSIBLE CAUSE	The driver pressed and held the DSC OFF switch for 5 s or more. Short to ground in the wiring harness between the DSC HU/CM terminal AP and the DSC OFF switch terminal C DSC OFF switch malfunction
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.