Generator Inner Parts: Rectifier

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Rectifier
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect for continuity of the diodes using a tester.
    Fig 1: Inspecting Continuity Of Diodes Using A Tester
    G04562935Courtesy of MAZDA MOTORS CORP.
    • If not as specified, replace the rectifier.
    RECTIFIER CONTINUITY CHART

    Tester Continuity
    Negative Positive
    E P1, P2, P3, P4 Yes
    B No
    P1, P2, P3, P4 E No
    B Yes
    Fig 2: Identifying Rectifier Terminals
    G04562936Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.