Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 638 (DYNAMIC STABILITY CONTROL SYSTEM)DSC CONFIGURATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
DSC Configuration
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION DSC Configuration
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the M-MDS or equivalent to the DLC-2.
- After the vehicle is identified, from the initial screen select the following items:
- When using the IDS (laptop PC)
- Select the "Module Programming"
- When using the PDS (Pocket PC)
- Select the "Programming"
- Select the "Module Programming"
- When using the IDS (laptop PC)
- Select "Programmable Module Installation".
- Select "ABS/TCS".
- Perform the configuration according to the directions on the screen.
- Retrieve DTCs using the M-MDS, then verify if DTCs are present.
- Clear DTCs using the M-MDS or equivalent, then verify that there is no DTC present.
- If a DTC is present, perform the applicable DTC inspection. (See ONBOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL] ).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.