Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 626 (ENGINE CONTROL SYSTEM)CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTIONCONTINUITY INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Continuity Inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Continuity Inspection
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the CPP switch.
- Verify that the continuity between CPP switch terminals B and D is as indicated in MEASUREMENT CONDITION AND CONTINUITY CHART .
- If there is no malfunction, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
- If there is any malfunction, replace the CPP switch.
MEASUREMENT CONDITION AND CONTINUITY CHART
| Measurement condition | Continuity |
|---|---|
| Push the rod. | No continuity |
| Except above | Continuity detected |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.