SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 623 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM])DTC P0703NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0703: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0703 DETECTION & CONDITION POSSIBLE CAUSES

DTC P0703 Brake switch input circuit problem
DETECTION CONDITION 
  • The PCM monitors the input signal from the brake switch when the following conditions are met. If the input signal does not change while alternately accelerating and decelerating 8 times, the PCM determines that there is a brake switch input circuit malfunction.

    MONITORING CONDITION 

    • Vehicle speed: decelerating more than 30 km/h {19 mph}  to 0 km/h {0 mph} 
    • Deceleration: more than 4 km/h {2 mph} per s 

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Brake switch malfunction
  • Connector or terminal malfunction
  • Open circuit in wiring harness between brake switch terminal A and PCM terminal 4P
  • Short to ground in wiring harness between brake switch terminal A and PCM terminal 4P
  • Open circuit in wiring harness between brake switch terminal C and ground
  • PCM malfunction
G04562669Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.