SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 623 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM])DTC P0032NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0032: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0032 DETECTION & CONDITION POSSIBLE CAUSES

DTC P0032 Front HO2S heater control circuit high
DETECTION CONDITION 
  • The PCM monitors the front HO2S heater control voltage when the PCM turns the front HO2S heater on. If the control voltage is less than 50% of the battery voltage, the PCM determines that the front HO2S heater control circuit voltage is high.

Diagnostic support note 
  • This is a continuous monitor (HO2S heater).
  • The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Front HO2S heater malfunction
  • Connector or terminal malfunction
  • Open circuit in wiring harness between main relay terminal C and front HO2S terminal C
  • Short to ground in wiring harness between main relay terminal C and front HO2S terminal C
  • Open circuit in wiring harness between front HO2S terminal D and PCM terminal 1V
  • Short to ground in wiring harness between front HO2S terminal D and PCM terminal 1V
  • PCM malfunction
G04562633Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.