Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 620 (SEATS)FRONT SEAT DISASSEMBLY/ASSEMBLY [EXCEPT L3 WITH TC]ANCHOR COVER DISASSEMBLY NOTE

2008 Mazda 6 s Sport, 4D Hatchback, Standard

Anchor Cover Disassembly Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Anchor Cover Disassembly Note

WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Remove the pins A and clips B from the side cover using a tape-wrapped flathead screwdriver.
Lift the anchor cover up in the direction of the arrow and remove it from the side cover.

Fig 1: Seat Anchor Cover

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.