SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 612 (AUTOMATIC TRANSAXLE [SHIFT MECHANISM])SELECTOR LEVER COMPONENT REMOVAL/INSTALLATIONNOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Selector Lever Component Removal/Installation: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts.
    1. Battery and battery tray
    2. Air cleaner component (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION [L3] ) (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION [AJ] )
    3. Center console
    4. Dashboard completely (See DASHBOARD REMOVAL/INSTALLATION. )
    5. SAS control module (See SAS CONTROL MODULE REMOVAL/INSTALLATION )
    6. Climate control unit (See CLIMATE CONTROL UNIT REMOVAL [L3, AJ] ) (See CLIMATE CONTROL UNIT INSTALLATION [L3, AJ] )
    7. Rear heat duct (See REAR HEAT DUCT REMOVAL/INSTALLATION [L3, AJ] )
  3. Remove in the order shown in the figure.
  4. Install in the reverse order of removal.
    Fig 1: Selector Lever Components & Torque Specification
    G04326465Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.