SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 596 (CHARGING SYSTEM (L3 WITH TC])GENERATOR DISASSEMBLY/ASSEMBLY [L3 WITH TC]PULLEY DISASSEMBLY/ASSEMBLY NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Pulley Disassembly/Assembly Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Pulley Disassembly/Assembly Note
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disassemble/assemble the pulley using the SST  .

    Tightening torque 

    60-85 N.m {6.1-8.7 kgf.m, 45-62 ft.lbf} 

    Fig 1: Generator Pulley
    G04325049Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.