SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 595 (AIR BAG SYSTEM)SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION [L3 WITH TC]
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Seat Weight Sensor Control Module Removal/Installation [L3 With TC]

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Seat Weight Sensor Control Module Removal/Installation [L3 With TC]
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When the seat weight sensor control module is replaced with a new one, perform the seat weight sensor calibration using the M-MDS. (See SEAT WEIGHT SENSOR CALIBRATION ).
  1. Turn the ignition switch to the LOCK position.
  2. Disconnect the negative battery cable and wait for 1 min or more. 
  3. Remove the front passenger's seat. (See FRONT SEAT REMOVAL/INSTALLATION [L3 WITH TC]. )
  4. Remove in the order indicated in the table.
    Fig 1: Removing Seat Weight Sensor Control Module (L3 With TC)
    G04326928Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.