SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 591 (FUEL SYSTEM (L3 WITH TC))FUEL INJECTOR REMOVAL/INSTALLATIONFUEL DELIVERY PIPE INSTALLATION NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Fuel Delivery Pipe Installation Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Fuel Delivery Pipe Installation Note
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the bolts in the order shown in the figure.

    Tightening torque 17-23 N.m {1.8-2.3 kgf.m, 13-16 ft.lbf} 

    Fig 1: Identifying Tightening Sequence Of Fuel Delivery Pipe Bolts
    G04324902Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.