SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 590 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM (AJ])OBD-II DRIVE MODENOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

OBD-II Drive Mode: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  • Using the OBD-II drive mode, the monitoring item requested by OBD-II regulations can be easily diagnosed.
  • Performing the Drive Mode inspects the OBD-II system for proper operation and must be performed to ensure that no additional DTCs are present.
  • The OBD-II drive mode is divided into the specific drive mode and single drive mode.
  • For the specific drive mode, specified drive modes have been set for each individual monitoring item requested by OBD-II regulations, and they can be diagnosed individually. For the single drive mode, the entire monitoring item requested by OBD-II regulations can be diagnosed.
  • The following modes are in the specific drive mode. The applicable system is diagnosed by driving in the following drive modes.
    • PCM Adaptive Memory Produce Drive Mode
    • EGR System Repair Verification Drive Mode
    • HO2S heater, HO2S, and TWC Repair Verification Drive Mode
    • EVAP System Repair Verification Drive Mode
  • The following systems are diagnosed with the single drive mode.
    • EGR system
    • HO2S
    • HO2S heater
    • Catalytic converter (TWC)
    • Fuel, misfire and evaporative (EVAP) system
      CAUTION:
      • While performing the Drive Mode, always operate the vehicle in a safe and lawful manner.
      • When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD function and inspect later.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.