SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 589 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM L3 WITH TC])DTC P2237NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P2237: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC P2237 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2237 Front HO2S positive current control circuit open
DETECTION CONDITION 
  • The PCM monitors the front HO2S positive current control circuit voltage. If the voltage does not change with the PCM control value while the engine is running, the PCM determines that the front HO2S positive current control circuit is open.

Diagnostic support note 
  • This is a continuous monitor. (HO2S)
  • MIL illuminates if the PCM detects the above malfunctioning condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction conditions during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTCs are stored in the PCM memory.
POSSIBLE CAUSE 
  • Front HO2S malfunction
  • Connector or terminal malfunction
  • Open circuit between PCM terminal 2D and front HO2S terminal 1A
  • PCM malfunction
G04324146Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.