SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 589 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM L3 WITH TC])DTC P0089NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0089: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0089 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0089 Fuel pressure regulator performance
DETECTION CONDITION 
  • If the fuel pressure average value measured by the PCM exceeds the specification when the camshaft is rotating at a specified rate, the PCM determines that there is a fuel pressure regulator performance problem.

Diagnostic support note 
  • This is a continuous monitor (Other).
  • The MIL does not illuminate.
  • FREEZE FRAME DATA is not available.
  • DTCs are stored in the PCM memory.
POSSIBLE CAUSE 
  • Spill valve control solenoid valve malfunction
  • Connector or terminal malfunction
  • PCM malfunction
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.