SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 581 (SECURITY SYSTEM AND LOCKS SYSTEM)CARD KEY ID CODE REGISTRATION [WITH ADVANCED KEYLESS SYSTEM]USING M-MDS
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Using M-MDS

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Using M-MDS
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fully lower the driver-side door glass.
  2. Connect the M-MDS to the DLC-2.
  3. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
    CAUTION:
    • Protect the cable and body contact area with a clean rag, otherwise they could be damaged.
      Fig 1: Locating DLC-2 Connector
      G04327333Courtesy of MAZDA MOTORS CORP.
  4. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Body".
      2. Select "Security".
    • When using the PDS (Pocket PC)
      1. Select "Programming".
  5. Then, select items from the screen menu in the following order.
    1. Select "Pats Functions".
    2. Select "Program Additional Card Key".
  6. Security access begins and the M-MDS displays the "OUT-CODE".
    NOTE:
    • When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times  will change the "OUT-CODE".
  7. Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed on the M-MDS screen.
  8. Select "CARD KEY PROGRAMMING" from the M-MDS screen menu.
    NOTE:
    • After Step  8 is completed and the card key programming is activated, the door lock actuator operates to lock, and then operates to unlock.
  9. Press the unprogrammed card key UNLOCK button twice.
    NOTE:
    • After Step  9 is completed and the card key is programmed, the door lock actuator operates to lock, and then operates to unlock.
  10. If programming more card keys, remove the supplementary key once, and then repeat the procedure from Step  7 by following the instructions on the M-MDS screen.
    Fig 2: Locating DLC-2 Connector
    G04327333Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.