SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 566 (FUEL SYSTEM (L3, AJ))FUEL INJECTOR REMOVAL/INSTALLATION [L3]NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Fuel Injector Removal/Installation [L3]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.
  1. Complete the "BEFORE REPAIR PROCEDURE". See BEFORE REPAIR PROCEDURE .
  2. Disconnect the negative battery cable.
  3. Remove in the order indicated in the table.
    Fig 1: Fuel Injectors & Torque Specification
    G04324821Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
  5. Complete the "AFTER REPAIR PROCEDURE".

    See AFTER REPAIR PROCEDURE .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.