Continuity Inspection

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Continuity Inspection
WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the following if the power steering is inoperative (See POWER STEERING FLUID INSPECTION ).
    • Power steering fluid level
    • Power steering fluid leakage
    • Power steering fluid pressure
  2. Disconnect the PSP switch connector.
  3. Start the engine.
  4. Inspect for continuity between the PSP switch terminal and ground using a tester.

Specification 

Fig 1: Terminals Continuity Table
G04325230Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.