SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 55 (ENGINE CONTROLS [THEORY & OPERATION])COMPUTERIZED ENGINE CONTROLSPOWERTRAIN CONTROL MODULE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Powertrain Control Module

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Powertrain Control Module
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Mazda Tribute, 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

The Powertrain Control Module (PCM), through various input sensors, monitors battery voltage, engine RPM, intake air volume, cranking signal, camshaft position, crankshaft position, intake air temperature, radiator and engine coolant temperatures, exhaust oxygen content, throttle position, EGR valve position, atmospheric pressure, gearshift lever position, clutch engagement, vehicle speed, braking, power steering operation, and A/C compressor operation.

The PCM utilizes this input information to control fuel injection system and operation of other output devices. Spark timing is also controlled by the PCM.

The PCM has a built-in fail-safe mechanism. If a fault occurs while driving, the PCM will substitute preprogrammed values. Driving performance will be affected, but vehicle may still be driven.

The PCM has a self-diagnostic function, which allows the module to store diagnostic trouble codes in its memory. A Malfunction Indicator Light (MIL), located on instrument cluster, informs driver of system problems.

ECM/PCM LOCATIONS

Application Location
B2300, B3000, B4000 & Tribute Passenger Side Of Cowl Area, Under Hood
Mazda6 Behind Of Dashboard, Left Of Steering Column
Miata Left Side Of Dashboard, Behind Brake Pedal Bracket
MPV Right Side Of Dashboard, Behind Air Duct
Protege & Protege5 Passenger Floor, Under Carpet
NOTE: Components are grouped into 2 categories. The first category covers INPUT DEVICES, which control or produce voltage signals monitored by the PCM. The second category covers OUTPUT SIGNALS, which are components controlled by the PCM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.