Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 543 (ON-BOARD DIAGNOSTIC (ABS/TCS))DTC C1119 [ABS/TCS]NOTES

2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC C1119 [Abs/TCS]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes

WARNING: This page is about a different car, the 2007 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DTC C1119 [ABS/TCS] DETECTION CONDITION AND POSSIBLE CAUSES

DTC C1119	Engine control system, torque reduction inhibit signal line
DETECTION CONDITION	Engine RPM information through CAN is out of specification or invalid value. Throttle information through CAN is out of specification or invalid value. Received control prohibition signal from PCM through CAN.
POSSIBLE CAUSE	Malfunction of PCM
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.