Windshield Wiper Motor Inspection

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Windshield Wiper Motor Inspection
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the windshield wiper motor connector.
  2. Apply B+ and inspect the operation of the windshield wiper motor as indicated below.
    Terminal Operation
    A High
    C Low
  3. Connect the windshield wiper motor connector.
  4. Turn the ignition switch to the ON position and turn the windshield wiper switch on.
  5. Turn the ignition switch to the LOCK position while the windshield wipers are operating.
  6. Verify that the windshield wipers do not stop in the park position.
  7. Disconnect the windshield wiper motor connector.
  8. Inspect for continuity between the windshield wiper motor terminals using an ohmmeter.
    Fig 1: Inspecting For Continuity Between Windshield Wiper Motor Terminals Using An Ohmmeter
    G03638982Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.