SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 533 (EXTERIOR TRIM)CONVERTIBLE TOP DISASSEMBLY/ASSEMBLYSET PLATE ASSEMBLY NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Set Plate Assembly Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Set Plate Assembly Note
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the convertible top over and fold it.
  2. Install the front of the top fabric to the front header.
  3. Align the set plate and top fabric with the set plate installation holes.
  4. Install the set plate to the link.
    Fig 1: Installing Set Plate To Link
    G03638843Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.