SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 489 (ON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM BP, BP WITH TC])AFTER REPAIR PROCEDURE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

After Repair Procedure

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION After Repair Procedure
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located the left side of the center console.
    Fig 1: Locating Vehicle DLC-2 16-Pin Connector
    G03637550Courtesy of MAZDA MOTORS CORP.
  2. Turn the ignition key from OFF to ON.
  3. Record DTC if retrieved.
  4. Erase all diagnostic data by WDS or equivalent
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.