Check code 31

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Check code 31
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
CHECK CODE 31 DIAGNOSTIC PROCEDURES

Check code 04 Door switch ON/OFF signal
STEP INSPECTION CONDITION DISPLAY ACTION
1 Remove the key from the steering lock, then reinsert the key into the steering lock after selecting check Code 31. (The key Reminder switch is on.) on Go to next step.
OFF Verify that the voltage of instrument cluster terminal 2W is B+.
Β 
  • If the voltage is as specified, replace the instrument cluster.
  • If the voltage is not as specified, inspect the following parts:
    • Key reminder switch
    • Wiring harness (Battery-key reminder switch- instrument cluster)
2 Remove the key from the steering lock. (The key Reminder switch is off.) on Verify that the voltage of the instrument cluster terminal 2W is 1.OV or less.
  • If the voltage is as specified, replace the instrument cluster.
  • If the voltage is not as specified, inspect the following parts:
    • Key reminder switch
    • Wiring harness (Key reminder switch-instrument cluster)
OFF Input signal to the instrument cluster is normal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.