Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 47 (ENGINE CONTROLS - SELF-DIAGNOSTICS)SYSTEM TESTSMALFUNCTION INDICATOR LIGHT
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Malfunction Indicator Light
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Malfunction Indicator Light
WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
- Carry Out The Instrument Cluster Warning Lamps And Chime Active Command Using Diagnostic Tool
Turn ignition off. Connect scan tool to DLC. Turn ignition on, engine off. Select instrument cluster WARNING LAMPS AND CHIME active command. Trigger ALL LAMPS active command. Observe Malfunction Indicator Lamp (MIL). If MIL is illuminating, refer to DIAGNOSTIC TROUBLE CODE DEFINITIONS . If MIL is not illuminating, go to next step. - Check For Correct Instrument Cluster Operation
Disconnect all instrument cluster harness connectors. Check for corrosion and pushed out pins. Reconnect all instrument cluster connectors and make sure they seat correctly. Operate system and verify concern is still present. If concern is still present, replace instrument cluster. Test system for normal operation. If concern is not present, system is operating correctly at this time. Concern may have been caused by a loose or corroded terminal or connector. Clear DTCs and repeat self-test. See CLEARING CODES and KOEO & KOER SELF-TEST under SELF-DIAGNOSTIC SYSTEM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.