SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 47 (ENGINE CONTROLS - SELF-DIAGNOSTICS)DRIVE CYCLE PROCEDURESMONITOR REPAIR VERIFICATION DRIVE CYCLESCATALYST MONITOR REPAIR VERIFICATION DRIVE CYCLE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Catalyst Monitor Repair Verification Drive Cycle

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Catalyst Monitor Repair Verification Drive Cycle
WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Ensure Vehicle Preparation has been performed. See VEHICLE PREPARATION . Drive vehicle in stop and go traffic. Include 5 different constant cruise speeds from 25-45 MPH over a 10 minute period. Verify no DTCs are set with exception of DTC P1000.

NOTE: Following procedure is designed to execute and complete Evaporative Emission Repair Verification Drive Cycle and to clear DTC P1000, Inspection Maintenance (I/M) readiness code. When ambient air temperature is below 40°F (4.4°C) or above 100°F (37.8°C), or altitude is above 8000 feet, EVAP monitor will not run. If DTC P1000 must be cleared in these conditions, PCM must detect them once (twice on some applications) before EVAP monitor can be bypassed and DTC P1000 cleared. EVAP bypassing procedure is described in following drive cycle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.