Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 44 (AIR BAG SYSTEM)TORQUE SPECIFICATIONS
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Torque Specifications
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Torque Specifications
WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Steering wheel nut | 29-36 (39-49) | |
| Seat belt | ||
| Lower anchor bolt | 29-57 (39-77) | |
| Lower pretensioner/retractor bolt | 29-57 (39-77) | |
| Shoulder anchor bolt | 29-57 (39-77) | |
| INCH Lbs. (N.m) | ||
| Clockspring screws | 7-10 (0.8-1.1) | |
| Driver-side air bag module retaining bolts | 70-104 (7.9-11.7) | |
| Passenger-side air bag module retaining bolts | 61-86 (6.9-9.7) | |
| SAS control module retaining nuts | 61-86 (6.9-9.7) | |
| Seat belt | ||
| Pretensioner/retractor lower mounting bolt | 61-86 (6.9-9.7) | |
| Webbing guide mounting bolts | 61-86 (6.9-9.7) | |
| Side air bag module nuts | 144-192 (16.3-21.7) | |
| Side air bag sensor | 70-104 (7.9-11.7) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.