Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 44 (AIR BAG SYSTEM)DISPOSAL PROCEDURESINSPECTING DEPLOYMENT TOOL
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Inspecting Deployment Tool
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Inspecting Deployment Tool
WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Deployment tool should always be inspected for proper operation before deploying air bag.
- Connect Red deployment tool clip to positive battery terminal. Connect Black deployment tool clip to negative battery terminal. Observe deployment tool lights. Green light should be on with Red light off.
- Connect deployment tool connector "A" to connector "B". See Figure. Green light should be off with Red light on. Press deployment tool activation switch. Green light should be on with Red light off.
- If deployment tool lights function as described, it is safe to use deployment tool to activate air bag. If deployment tool lights DO NOT function as described, DO NOT use deployment tool. Replace deployment tool with another unit and repeat procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.