Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 431 (SYMPTOM TROUBLESHOOTING [ENGINE])ENGINE CONTROL SYSTEM OPERATION INSPECTIONINTAKE MANIFOLD VACUUM INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Intake Manifold Vacuum Inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Intake Manifold Vacuum Inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Verify air intake hoses are installed properly.
- Start the engine and run it at idle.
- Disconnect the vacuum hose between the intake manifold and purge solenoid valve from the intake manifold side.
- Connect a vacuum gauge to the intake manifold and measure the intake manifold vacuum.
- If not as specified, inspect the following:
- Air suction at throttle body and intake manifold installation points
- Fuel injector insulator
- Engine compression
- (See COMPRESSION INSPECTION .)
Specification
- MT: -66.7- -56.0 kPa {-500.24- -420.1 mmHg, -19.6- -16.6 inHg}
- AT: -67.3- -53.4 kPa {-504.7- -400.6 mmHg, -19.8- -15.8 inHg}
NOTE:- Air suction can be located by engine speed change when lubricant is sprayed on the area where suction is occurring.
- If not as specified, inspect the following:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.