Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 431 (SYMPTOM TROUBLESHOOTING [ENGINE])ENGINE CONTROL SYSTEM OPERATION INSPECTIONDRIVE-BY-WIRE CONTROL SYSTEM INSPECTIONENGINE COOLANT TEMPERATURE COMPENSATION INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Engine coolant temperature compensation inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Engine coolant temperature compensation inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the WDS or equivalent to the DLC-2.
- Select the following PIDs:
- ECT
- IAT
- RPM
- Verify that the engine is cold, then start the engine.
- Verify that the engine speed decreases as the engine warms up.
- If the engine speed does not decrease or decreases slowly, inspect the following:
- ECT sensor and related wiring harness
- Throttle body and related wiring harness
(See THROTTLE BODY INSPECTION .)
- If the engine speed does not decrease or decreases slowly, inspect the following:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.