SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 418 (AIR BAG SYSTEM)SAS CONTROL MODULE CONFIGURATION (TWO-STEP DEPLOYMENT CONTROL SYSTEM)
2008 Mazda 6 s Sport, 4D Hatchback, Standard

SAS Control Module Configuration (Two-Step Deployment Control System)

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION SAS Control Module Configuration (Two-Step Deployment Control System)
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the WDS or equivalent to the DLC-2 (16-pin).
  2. Select "Module programming" from the menu.
  3. Select "Programmable Module Installation".
  4. Select the following items and perform procedure according to the directions on the WDS screen.

    Item 

    1. "RCM" 
    Fig 1: Locating DLC-2
    G03700863Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.