SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 412 (POWER STEERING SYSTEM)STEERING GEAR AND LINKAGE DISASSEMBLYRACK BUSHING DISASSEMBLY NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Rack Bushing Disassembly Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Rack Bushing Disassembly Note
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the SST  to the gear housing rack end.
  2. Remove the steering rack component from the rack housing.
  3. Remove the SST  , rack, bushing, and oil seal from the steering rack.
    Fig 1: Attaching SST To Gear Housing Rack End
    G03700652Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.