SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 412 (POWER STEERING SYSTEM)STEERING GEAR AND LINKAGE ASSEMBLYTIE ROD ASSEMBLY NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Tie Rod Assembly Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Tie Rod Assembly Note
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Secure the teeth section of the rack in a vise.
  2. Tighten the tie rod using the SST  .

    Tightening torque 

    1. 78-98 N.m {8.0-9.9 kgf.m, 58-72 ft.lbf} 
  3. Caulk the washer.
    Fig 1: Tightening Tie Rod Using SST
    G03700678Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.