Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 412 (POWER STEERING SYSTEM)STEERING GEAR AND LINKAGE ASSEMBLYHOUSING COVER ASSEMBLY NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Housing Cover Assembly Note
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Housing Cover Assembly Note
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Be careful not to apply too much sealant.
- Apply sealant to the threads of the housing cover.
- Mount the housing cover.
Tightening torque
- 49-69 N.m {5.0-7.0 kgf.m, 37-50 ft.lbf}
- Caulk one point of the housing cover and gear housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.