SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 412 (POWER STEERING SYSTEM)STEERING GEAR AND LINKAGE ASSEMBLYBOOT ASSEMBLY NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Boot Assembly Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Boot Assembly Note
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the boot.
  2. Install the boot band onto the large end of the boot as shown.
    Fig 1: Installing Boot Band Onto Large End Of Boot
    G03700679Courtesy of MAZDA MOTORS CORP.
  3. Verify that the boot is not twisted and dented while moving the rack fully forward and back.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.