Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shift Cable
Move gearshift lever to Park position. Remove steering column covers. See Fig 1 . Loosen nut on gearshift lever cable. Pull gearshift lever rearward to Reverse position, to side gate of Park position. Tighten nut on gearshift lever cable to specification. See TORQUE SPECIFICATIONS . Verify that the gearshift lever bolt end is exposed from the nut. See Fig 2 . Install steering column covers. See Fig 1 .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.