Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 368 (POWER STEERING SYSTEM)AIR BLEEDING
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Air Bleeding
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Air Bleeding
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not turn the steering wheel during the fluid level inspection, otherwise the fluid level changes and cannot be inspected correctly.
- Inspect the fluid level. (See POWER STEERING FLUID INSPECTION .)
- Jack up the front of the vehicle and support it on safety stands.
- Turn the steering wheel fully to the left and right several times with the engine not running.
- Reinspect the fluid level.
- If it has dropped, add fluid.
- Repeat Steps 3 and 4 until the fluid level stabilizes.
- Lower the vehicle.
- Start the engine and let it idle.
- Turn the steering wheel fully to the left and right several times.
- Verify that the fluid is not foamy and that the fluid level has not dropped.
- If the fluid level has dropped, add fluid as necessary and repeat Steps 8 and 9.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.