Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transaxle Oil Replacement
- Remove the drain plug with the gasket.
- Drain the oil into a suitable container.
- Install a new gasket and the drain plug.
Tightening torque
30.0-39.0 N.m
{3.1-3.9 kgf.m, 22.1-28.8 in.lbf}
- Remove the filler plug with gasket and add the specified amount and type of oil through the filler plug hole until the level reaches the bottom of the filler plug hole.
Specified oil grade
API Service GL-4 or GL-5
Specified oil viscosity
SAE 75W-90
Capacity (approximate quantity)
2.3 L {2.4 US qt, 2.0 Imp qt}
- Install a new gasket and the filler plug.
Tightening torque
30.0-39.0 N.m
{3.1-3.9 kgf.m, 22.1-28.8 in.lbf}
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.