SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 364 (MANUAL TRANSAXLE [SERVICE, REMOVAL & INSTALLATION A65M-R))MANUAL TRANSAXLE REMOVAL/INSTALLATIONNO. 1 ENGINE MOUNT INSTALLATION NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard

No. 1 Engine Mount Installation Note

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION No. 1 Engine Mount Installation Note
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hole of the No. 1 engine mount rubber with the bolt hole of transaxle.
  2. Lightly tighten bolt A, then tighten bolts B and C.
    Fig 1: Identifying No. 1 Engine Mount Bolts
    G03644657Courtesy of MAZDA MOTORS CORP.
  3. Tighten bolt A.

    Tightening torque 

    66.6-93.1 N.m 

    {6.8-9.4 kgf.m, 49.2-68.6 ft.lbf} 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.